Model #TITAN 7 MODEL 12-600171-02 MCCULLOCH Chainsaw

  • General Assembly
    3 Results
  • Chain Brake Assembly
    3 Results
  • Powerheas Assembly
    3 Results
  • Handle Assembly
    3 Results
  • Carburetor Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Sportspower Titan Table Tennis Model# GMT-3258-PB.

A:

I have contacted the manufacturer to obtain the manual for that table. I will update this thread once I receive that manual.

Read More
Lyle W -
Sears Technician
August 28, 2012
Q:

Ignitor for Bosch Model HGS435UC/02

A:

Thank you for your question and I understand your concern.

The problem very well could be the bake igniter. The bake igniter must glow red and it must pull enough current to cause the oven gas valve to open. If the bake igniter is glowing, I suspect the igniter is too weak to pull enough current to cause the gas valve to open. Replace the bake igniter and the oven should ignite.

If the bake igniter is not glowing, it could have a broken igniter, a faulty electronic oven control or possible a faulty oven safety valve. The igniter can be disconnected and tested for continuity with an Ohm meter. NOTE: Disconnect the power cord from the power source before servicing the range.

The bake igniter #492431 for Bosch model HGS435UC/02 can be ordered from Sears Parts Direct.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
July 05, 2012
Q:

What does F 02 mean on Kenmore washer model number 11045862402?

A:

The F 02 indicates a long drain time. The sud code comes up first to indicate a suds lock. If you have excessive suds, this can keep the washer from draining properly.

Since the washer is not draining the water properly, this indicates that you may have a clogged drain. Check the drain hose for a kink or clog. Make sure that the washer drain is not clogged or restricted. It is likely that you will need to unplug the washer and pull the large item filter on the pump to remove a clog or restriction. The first image shows how to remove the bottom front service panel on the washer. The second image shows how to remove the large item filter on the pump. Be sure to remove any water from the washer tub before pulling this large item filter. Arrange towels to catch residual water that will flow out of the opening when the filter is removed. Remove the bottom service panel and the large item filter and check for a clog or restriction that could be preventing the washer from draining.

If you find no problems in this area and the drain hose and washer drain are clear, then you may need to replace the drain pump to correct this problem.

If you need parts, you can order them from the Sears PartsDirect website.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
May 01, 2009