Model #SUPER TOMAHAWK 8HP TROYBILT Chipper Shredder/Vacuum, Gas

  • Drawing One
    3 Results
  • Drawing Two
    3 Results
  • Drawing Three
    3 Results
  • Drawing Four
    3 Results
  • Drawing Five
    3 Results
  • Drawing Six
    3 Results
  • 8hp Briggs & Stratton Electric Start System
    3 Results
  • 5hp Tecumseh Electric Start System
    3 Results
Find part by diagram >

Question and Answers

Q:

Troy Bilt Super Tomahawk Chipper. I am looking for cutting blade or serial number for cutting blade. It is an 8hp engine. How or where do I find it?

A:

I am sorry you are having a problem finding parts for the Troy built. I tried to look up parts for you on the Troy built site but did not have any luck. It said the model number is invalid. I recommend clicking on the link below. The link will take you to the Troy built site. Once there is will show you where to find the model number. Once you find the model number, you can look up the parts on their site. I hope this is helpful. Please let me know if you need further assistance. Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
May 19, 2012
Q:

need owners manual for a TROYBILT Super tomahawk 8 hp chipper/shredder model 4990

A:

Thank you for your question.

  • Unfortunately the manuel you are looking for is not available. If you need any parts information please contact MTD products at 1-800-800-7310 and they may be able to help you.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
August 19, 2010
Q:

My 8hp Briggs lets compression through the carb when trying to start it.

A:

You need to check the valves when the piston is at top dead center of the compression stroke. You can see the valves to tell if there is any pressure at this position. If the valves are not totally relaxed when the piston is at the top and the magnets on the flywheel are at the ignition module, the gear on the cam shaft might have spun on the shaft.

If you did grind the intake valve you must have removed the head. Were the valve seats ok? Did you look at the wear marks on the seats to see if they were uniform? Did you grind the seats?

Send another email with answers to these questions and we will try to help.

Read More
Jimmy K -
Sears Technician
March 26, 2009