Model #SR-6-1 EMPIRE Air Handler-Auxiliary Heater Kit

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Can I reset the code of Craftsman garage door opener model 139.53615SR?

A:

Your garage door opener model 139-53615SR has the Smart Receiver. It is programmed by simply pressing the SR button in the rear of the motor housing. Press the SR button, do not hold it down.

I recommend that you clear all of the old codes on your remotes. You can clear the old code by holding the SR button down until the LED light goes out. This procedure takes just a few seconds. Once the code has been removed, reprogram your remotes by using the procedures in the image below.

Holding the SR button down will once again remove any code that you have put in, press and release the SR button. You have 30 seconds to reprogram your remotes.

For more help with this garage door opener problem, resubmit your question with additional details.

If you still need help with this garage door opener please let me know and I will be glad to help you.

Sam A.

Read More
Sam A -
Sears Technician
April 17, 2012
A:

apologize that I have not answered you before this time on your problem with the garage door opener. If you still need help with this problem please let me know. If this is a craftsman garage door opener then you should only have to hold the learn button on the back of the unit for usually not more that 6 seconds and the light should go out. If the light is not going out then the control board is not functioning correctly. If this is a Genie garage door opener then you should also be able to clear the memory out of your opener. Your neighbor must have a remote button down on one of his remote to be able to operate your door when you try to program yours. Please let me know what you find out. Sam A.

Read More
Sam A -
Sears Technician
April 17, 2012
See more answers
Q:

Im having issues getting my infrared sensors to operate the door. Can I disconnect this part, and gargare door still operate properly?

A:

Those links for previous answers that Marc H. posted in the above response correctly indicate that you cannot bypass those sensors. You can test them with short pieces of wire. If you use some short runs of wire and connect the sensors to the motor unit and hold them an inch or so apart then test the garage door operation, you should be able to tell if the sensors and the motor unit/logic board are good. You should not use that process to bypass the sensors. If the sensors work properly when tested in the above manner then you probably have a wiring failure between the motor unit and the sensors when they are installed on the rails at the bottom of the door opening. If the opener does not work properly when those sensors are tested in that manner, then you could have a problem with the sensors or the logic control board in the opener.

I hope that this information helps.

If you need parts, you can order them from this page: Craftsman Garage Door Opener 139.53614SR Parts .

If you need more help, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
May 11, 2012
Q:

6 1/2 Jointer/Planer

A:

Thank you for your question.

I can understand wanting to have the owner's instruction manual for your Jointer/Planer.

I have e-mailed a copy to you.

If you want an original paper copy the you can order it.

The part number for the manual is: 67096 and you can purchase it from: Sears Parts Direct .

The manual is about $7.50 plus shipping.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
March 23, 2011