Model #SD-P5047K PIONEER Projection/Digital 42" and above TV

  • No Image Available - Fidelitone
    3 Results
Find part by diagram >

Question and Answers

Q:

What does "Sd" mean on my washer?

A:

The "Sd" error code is an indication of Suds Lock (overdose of detergent detected during the wash cycle).

High Efficiency (HE) detergent is recommended which is a low sudsing detergent. Note: Using too much of the recommended HE detergent will also cause too many suds and cause "Sd".

I recommend not adding any detergent and rewash the clothes that did not rinse well. You will most likely see a lot of suds indicating that you are using too much or the wrong kind of detergent.

Read More
Joey S -
Sears Technician
August 20, 2008
Q:

what is sd or 5d mean

A:

Thank you for your question and I understand your concern.

The "sd" indicates the oven control is in the Sales Demo mode.

A sales demo (SD) mode is available that allows the TSC panel functions to be demonstrated without turning on any heating elements.

To enter or exit the SD mode disconnect power to the range. Reconnect the power and within 45 seconds touch the "OVEN COOK TIME" keypad on the TSC panel and hold until "sd" appears in the EOC display (approximately 6 seconds). The time of day display will blink until the clock is set. In the Sales Demo mode all control panel and display functions can be demonstrated but the elements will not heat.

To exit the Sales Demo mode you must repeat the procedure used to enter the Sales Demo mode. Disconnect the power to the range; reconnect the power and within 45 seconds touch and hold the "OVEN COOK TIME" pad until the "sd" display disappears. You can not exit the Sales Demo mode by pressing the Stop/Clear keypad or by resetting the power to the range.

This may be the issue. If not, please reply and I will be glad to assist you further.

Read More
Joey S -
Sears Technician
November 06, 2012
A:

Jenn: Try using the "Bake Time" button in place of the "Cook time".

Read More
Joey S -
Sears Technician
November 18, 2012
See more answers
Q:

What would cause a F21 and Sd error codes?

A:

The error code F21 and Sd is indicating a draining problem. Taking too long to drain or not draining at all.

LONG DRAIN

If the drain time exceeds 8 minutes the water valves turn off. NOTES:

? After four minutes the “Sd� error will be displayed, then four minutes later the “F/21� error code will be displayed.

? Press PAUSE/CANCEL two times to clear the display

Possible Causes / Procedure

1. Check the drain hose and make sure it is not plugged or kinked.

2. Unplug washer or disconnect power.

3. Check the electrical connections at the pump and make sure the pump is running.

4. Check the drain pump filter for foreign objects.

5. Plug in washer or reconnect power.

6. If the above does not correct the problem, go to step 7.

7. Unplug washer or disconnect power.

8. Replace the pump.

To access the pump, remove the 3 screws at bottom of the toe panel. Note: Disconnect power or unplug the washer before removing the toe panel. I added some images showing the toe panel and screws (key#21). The second image shows the filter (key#14). You will need to get all the water out of the tub before removing the pump filter. If you have a wet/dry vacuum connect it to the end of the drain hose and draw the water out. Have some towel handy when you remove the filter.

Read More
Joey S -
Sears Technician
May 30, 2008