Model #SAT-A3 SONY digital satellite system

  • Cabinet
    3 Results

Question and Answers

Q:

mower sat for several years

A:

 

Thank you for your question and I understand your concern.

 Since it sat up so long, it could have stuck piston ring or it could have possibly have a broken ring allowing the crankcase to build up pressure and blow out oil. It could have a rocker arm or push rod issue too.

Also, make sure it is not overfilled with oil too. It could also have stopped up crankcase breather too. On the side of the engine normally near the carburetor is a rectangle cover called the "Breather" and it will normally have rubber tube connecting the breather to the bottom of the air filter box. If the crankcase breather is stopped up and not letting the crankcase pressure vent, it can cause oil to blow up through the carburetor. 

If the crankcase breather is clean and working correctly and you're not able to get the unit started, I strongly suggest calling a service technician to come out or take the mower in for an estimate and/or repair. 

 

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services.

 

Read More
Joey S -
Sears Technician
April 12, 2013
Q:

The mower sat for years, and won't start. What should I do?

A:

I think you need to rebuild or replace the carburetor. You can order a kit to overhaul the carburetor (part number 632760B $20.00), or a new carburetor (part number 640262A $70.00).

If you overhaul the carburetor you need to let it soak in carb cleaner several hours. Run a soft wire through each fuel and air passage inside the carburetor and blow them out with compressed air.

If the inside of the carburetor has a white substance built up on the metal of the body you should replace the carburetor. This residue is from the water in the old fuel attacking the metal and will continue to stop up the fuel passages. It can't be corrected.

Read More
Jimmy K -
Sears Technician
September 08, 2008
Q:

kENMORE FRIDGE 596.72289200 MOVED IT on Sat. it's Mon and still not cold. I plugged it in after it was in place Sat. but unplugged on Sunday to clean (vaccum)

A:

You did not say if it was transported or not, just moved. If it was laid on its back or sides then it could have an oil restriction in the capillary tube. Turn the unit off and let it sit for 12 hours and then start it up. If the fans are running and the compressor is hot and not running then the compressor could be locked up or a faulty overload and relay assembly. If the compressor is running and both fans are running be sure the rear cover is installed over the compressor area or the fan will not draw air over the condenser coils and cause it to not cool.

If everything appears to be running and in place then based on your symptom you will need to call a service technician to diagnose and repair your refrigerator. I recommend calling 1-800-4MY-HOME or 1-800-469-4663 and setting up an appointment.

Read More
Joey S -
Sears Technician
May 19, 2010