Model #S2211-100 HOOVER Carpet/Floor Sweepers

  • Powerednozzle, Hose, Motorhousing
    3 Results
Find part by diagram >

Question and Answers

Q:

range does not get higher than 100 degrees

A:

Thank you for your question and I understand your concern.

Based on your symptom and details, the high limit thermal switch has likely tripped during the high heat of the self clean cycle. The thermal switch is located on the back of the range and will likely have a red wire with a white stripe and a black wire with a white stripe connected to it. You will need to remove the range and take the rear panel off in order to access the thermal switch. There will be a red reset button in the middle of the thermal switch to push and reset. There are no video or written instructions. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

NOTE: Disconnect the range from the power supply before removing the back panel and resetting the thermal switch. I strongly suggest calling a service technician to diagnose why the thermal switch tripped.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
February 13, 2012
Q:

TEMPERATURE 100 DEGREES HIGHER

A:

Thank you for your question and I understand your concern.

If you're sure the thermometer you are using is accurate, you will likely need to replace the oven thermostat or just set the thermostat 100 degrees lower than need be. The oven temperature calibration adjustments are made by loosening the two screws on the back side of the thermostat knob and rotating the skirt. I added an image below with the calibration instructions.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
February 23, 2012
Q:

100 series table saw

A:

Thank you for your request for a manual on this 1963 table saw.

I can help you with the parts list which is in the owners manual I have e-mailed you but I cannot help you with any accessories because of its age.

I need to inform you that most of the parts for this table saw are no longer available.

The saw did not come with a motor at that time. You would purchase the table saw and then go over to the motor group and pick the motor you wanted to put on it.

If you have any other questions on the saw please let me know.

Sam A.

Read More
Sam A -
Sears Technician
April 18, 2012