Model #R-1872 SHARP microwave/hood combo
Question and Answers
how do I R & R this part touchpad #97013466
There is not a procedure available for the replacement of the touchpad on that older Kenmore range hood. These general tips may help you complete that repair:
Shut off the house circuit breaker to disconnect electrical power and remove the filter on the side that has that touchpad. You may be able to disconnect that wires and pull that touchpad out after removing that filter. If not, then you may need to remove the blower motor and/or other components. The owner's manual/installation guide will normally provide directions for removing the blower motor. You may need to pull the range hood down to access that touchpad. You can view the parts image for the blower on this page: Kenmore Range Hood Model 233.5548910 Parts . The parts diagram may help you access and replace that part.
If you get to the point where you need to have a service technician replace that touchpad, you can schedule service through this link: Sears Home Services .
Here is the image.
Gas Footvalve R&R JGP330EP2BG
Thank you for your question and I understand your concern.
Yes, the glass top must be taken off to access the burner valve. I added an image below with the procedure of removing the glass top. NOTE: Turn the gas supply off and disconnect the power cord from the power source before servicing.
I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.
"R" Status Code Light
I do not find information on that model of Carrier furnace. You can recheck that number and reply with an update if it is incorrect.
If that is the model number, I recommend that you have the unit serviced by a technician. The growling noise is likely a mechanical failure in the fan that will need to repaired. Here is a link for the Sears Service website: Sears Home Services .