Model #PT-56D30CB PANASONIC Projection/Digital 42" and above TV

  • Cabinet Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

how to replace hinges on oven model # 79046373402 pt # 318024741

A:

The images below show that basic procedure for replacing the hinges on that type of oven door. Your model number indicates that you have a stainless steel model. You will need to remove the door from the oven as shown in that first image. Caution: That oven door is heavy. Two people may be needed to safely lift that door off of the oven and place it on a padded surface . You should then be able to use the information in the second and third images to remove and replace the hinges. If you need more help, let us know.

If you get to the point where you need to have a service technician complete this repair, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
February 29, 2012
Q:

CRAFTSMAN TABLE SAW MOTOR REPLACEMENT

A:

Thank you for your question on the motor for you table saw.

The replacement motor you are looking for on your table saw, as you probably already know is no longer available.

Because these direct drive motor are a proprietary motor there is no substitute.

I am sorry that I could not help you with a replacement motor.

If you have not already done so you could call the table saws manufacturer's customer support line at 1-800-843-1682 to see if they have any motor options for your saw.

Again, I apologize that we can no longer supply you with a replacement motor for your saw.

Thank you for using Manage My Life.

Sam A.

Read More
Sam A -
Sears Technician
August 19, 2011
Q:

I purchased and installed switch plunge pt.#121305X, ignition switch pt.#175566, interlock switch pt.#176138 for craftsman DLT 3000 riding mower #917.273821.

A:

Thank you for your question.

Your Tractor uses an Operator Presence (seat) switch that will cause engine to stall if blades are engaged or the brake is released without anyone on the seat. If ample amount of weight is not kept on the seat during operation or the operator is leaning forward the tractor will stall because the Operator Presence (seat) switch senses that the operator is not completely on the seat.

To check Operator Presence (seat) switch:

  1. Lift seat.
  2. Locate wires that connect to Operator Presence (seat) switch under the seat.
  3. Disconnect and clean any debris in the switch connector. Use an ohmmeter to check the switch. When the switch is not pushed, the reading should be 0 ohms (closed). When pushed it should read ol ( open load )
  4. Make sure the connector is fully seated on the seat switch. The connector is a special connector that will short the two wires if it is not fully seated.

I hope this is helpful.

Please click on the following link to order the parts you need. Sears Parts Direct

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Please let me know if you need further assistance.

Thank you for using Mange my life.

Mark T.

Read More
Mark T -
Sears Technician
January 02, 2012