Model #PRO MAC 610 11-,12-600041-08 LOWRANCE Chainsaw, Gas

  • General Assembly
    3 Results
  • Powerhead And Oiler Assemblies
    3 Results
  • Chain And Brake Assembly
    3 Results
  • Fan Housing And Fuel Tank Assemblies
    3 Results
  • Carburetor Assembly
    3 Results
  • Carburetor
    3 Results
  • Brake Housing
    3 Results
  • Carburetor
    3 Results
Find part by diagram >

Question and Answers

Q:

Pro Mac Mcculloch chain saw 610, Model # 60041

A:

Thank you for sending the model number for you McCulloch chain saw.

The model 610 is a good model saw.

Do you have a question about the saw?

I will glad to help you.

Sam A.

Read More
Sam A -
Sears Technician
June 05, 2012
Q:

Why won't the lower oven on my Kenmore range model 790.98022800 heat after I cleaned it?

A:

The wiring diagram for your range is shown in the first image below. The lower oven element circuit is traced in red. There is a safety thermostat in this circuit that will prevent all of the lower oven elements from heating if it is "open". The second image below shows the location of this safety thermostat. If you unplug the range and remove the lower back panel, you should be able to access this thermostat and check it for continuity. Remove one wire and measure the resistance of this component with a volt/ohm meter. You should measure near zero ohms of resistance. If you detect an open load (Ol or infinite resistance) then the thermostat is bad and will need to be replaced. You can order a new thermostat from the Sears PartsDirect website. The part number for the thermostat is 318004902.

If the thermostat is okay, I recommend that you check the wiring connections of the lower oven element circuit on the control board (with the range still unplugged). If the wiring and the elements are okay, then you could have a failed control board. I recommend that you have a service technician diagnose and repair this type of problem. Here is a link for the Sears Service website in case you need it: Sears Home Services .

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
March 31, 2010
Q:

Why did my bearings/belt/brush roll on my canister vacuum need repair? It was purchased 7/08, repaired 12/08.

A:

There was a problem with hair and debris collecting around the brush roller and causing the bearings for the roller to overheat. The roller was redesigned and a bulletin was issued for your vacuum. All stock of the original roller was purged from inventory and only the improved version can be ordered.

You should not have to worry about the problem occurring again. Always check and clean the roller monthly or bi-monthly if usage is light.

Read More
Jimmy K -
Sears Technician