Model #P-FMD16F10001A YORK furnaces/heaters
Question and Answers
Need P/N for Spring Retainer
Thank you for your question about the slide spring for the drawer.
There has been a change in the spring style and the current part number is M3163.
You can look at a picture of the part on line.
Look at the sight below.
I hope this will help.
Sam A.
Thank you for you patience of finding this part. I have discovered that this part is part of the slide assembly and you will have to replace the slide. The part number for the slide is: M12923. I have listed the part in the link below. Would it be possible to use a pop rivet gun and a pop rivet to reattach the part? Sam A.
Craftsman P/N 874177-00
Thank you for your question on the old saw part number.
You are correct in that this part is no longer available.
Since this saw was built by Black and Decker you may be able to find a part from them.
The Black and Decker model is a 9425- type 1 or 2.
I do not know what the size and LH thread are on the blade retainer screw.
Black and Decker blade screw .
You might try the link above to see if they can provide it.
I hope this will help.
Sam A.
Why are there NO grooves in Kit 187879GS for installing P/N 97845GS???
The o-ring in this kit is used as a washer. It does not fit into a groove. Install the o-ring in its proper position and it will work fine.