Model #MFC-690 BROTHER fax machines

  • Unit
    3 Results

Question and Answers

Q:

How do I change the hinges on my oven door?

A:

The model number of your Kenmore range/oven submitted is not a valid model number. Re-verify the model number of your range/oven and resubmit your question with the model number for model specific instructions.

Read More
Joey S -
Sears Technician
November 02, 2009
Q:

I need to remove a bottom drawer from a Craftsman 5 drawer tool cabinet in order to install casters. Model number 706 597 690. Sears refuses to help.

A:

Thank you for your question.

Not being able to get the drawer out can be very inconvenient.

I am sorry that you did not get any help.

I have a couple of pictures that may help you.

I hope this will help you remove the drawers.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
December 30, 2010
Q:

Help for a slide in range?

A:

Your current problem (with the control not powering up unless turn on one of the burners) is likely caused by a voltage supply failure. The wiring diagram for your range is shown in the image below. The green line on that diagram shows the normal voltage supply for the control board. That wire traced in green is probably black in color. It is likely that you are missing that leg of power to the control board. The red line on that diagram traces the voltage path that is apparently causing the control to light up when a burner is turned on. The L2 leg of power is applied to the L1 circuit through the burner switch and the element as shown in that diagram. I recommend that you check the house circuit breakers for the range. You may find that one of those breakers is tripped. Some houses have fuses instead of breakers. If you can restore that power to the range, then the stove top elements should heat properly. If the control for the oven still does not work properly after restoring power, then you may have a problem with the electronic control board on that range. That electronic control board is no longer available as a replacement part. If it needs repair, it would need to be sent to a Core Centric Solutions for repair. Here is a link for the website for that company that has contact information: CoreCentricSolutions.com . The cost for repairing that type of electronic control board is normally around $150. Be sure that you shut off the house circuit breakers for the range before accessing internal components and removing that control board.

These tips may help you fix this range problem on your own. If you need more help, reply with additional details.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 05, 2012