Model #KUDL02IRBS1 KITCHENAID Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm And Strainer Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >


Error Codes

Error Code:



Question and Answers


Why does my KitchenAid dishwasher model KUDL02IRBS1 leave water in the bottom of the tub after all cycles that I run?


Several different problems could prevent the dishwasher from draining properly. Here are some issues to check:

  • Check to see if the dishwasher will drain the remaining water by using the CANCEL/DRAIN button. This will normally cause the drain pump to run when the door is closed. If the dishwasher still won't drain, check the air gap on the sink if you have one installed. A clogged air gap can prevent the dishwasher from draining properly.
  • Check the drain hose for a clog. Make sure that it is properly installed with an anti-siphon loop in the drain hose.
  • A problem in the sump area could prevent the dishwasher from draining. The image below shows how to access the sump area in this type of dishwasher. Your model is slightly different than the one shown below but the basic procedure is the same. If you are able to shut off the breaker for the dishwasher and access the sump area, you can check the drain check valve shown below.
  • A failed drain pump or a problem with the control board could prevent the dishwasher from draining. A technician would normally need to diagnose and repair this type of problem.
If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
September 22, 2009

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show