Model #KERA205PSS1 KITCHENAID Free Standing, Electric

  • Cooktop Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Chassis Parts
    3 Results
  • Door Parts
    3 Results
  • Drawer & Broiler Parts, Optional Parts
    3 Results
Find part by diagram >

Question and Answers


error code KERA205PSS1


  • F1 E3 Configuration mis-match. Configuration jumper change; freestanding, electric switches or P3 pins 3 to 7 changed since power up.
  • F1 E4 Oven sensor calibration. Oven sensor not calibrated. Run calibration routine.
  • F1 E5 Meat probe calibration. Meat probe not calibrated. Run calibration routine.
  • F1 E6 Display board. Display board EPROM access. Replace display board.
  • F1 E7 Power board E2. Power board EPROM access. Replace power board.
  • F1 E8 Power board supply lift. Improper keypad feeding. Replace power board.  Click here for part.
  • F1 E9 Keyboard gain. Unstable keyboard gain. Replace display board.
  • F1 EA Stack warning. Exceeded stack warning level. Reset power. If problem persists, replace power board.
  • F2 E0 Keypad disconnect. User is cleaning too long or keypad is disconnected. 1. Check keypad connections. 2. If problem persists, clean switch surface.
  • F2 E1 Cancel key. Cancel key invalid. Needs surface cleaning.
  • F2 E3 Keypad spill. Key held down too long or keyboard short or spill on switch surface. Needs surface cleaning.
  • F3 E0 Open oven sensor. Oven sensor open. Replace oven sensor.
  • F3 E3 Shorted oven sensor. Shorted oven sensor. Replace oven sensor.
  • F3 E4 Oven temperature too high. Oven temperature too high (runaway). Replace oven sensor, or control.
  • F4 E0 Shorted meat probe. Meat probe shorted (less than 1500 ohms). Replace meat probe.
  • F5 E1 Self clean latch. Self clean latch not locking. Check latch system.
  • F5 E5 Clean temperature. Self clean temperature not achieved after 30 minutes. Check door hinge and door seal gasket.
  • F5 E7 Clean unlatch. Door unlocked but will not unlatch. Check door switch, latch switch, and rod mechanism.
  • F7 E0 Latch switch. Invalid latch switch reading. Check latch switch.
  • F7 E1 Door switch. Invalid door switch reading. Check door switch.
PF Power Failure (Not a Failure Mode) Push CANCEL. (Do not replace control.)

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website:Sears Home Services .

Read More
Sherman_G_Wallace -
Sears Technician
November 25, 2013

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show