Model #JGCP430ADP JENN-AIR Counter Unit, Gas

  • Control Panel/manifold Pipe
    3 Results
  • Top Assembly
    3 Results
  • Burner Box
    3 Results
  • Supplemental Information
    3 Results
Find part by diagram >

Question and Answers


jenn air 30" gas cooktop - ignitor questions


I understand how frustrating this can be. While you are waiting on an expert to answer your question, I suggest you service with a Sears technician. I have attached the link below. Have a nice day!

Read More
Dezeray -
July 07, 2012

is this just a marketing tool? or will someone eventually try to answer the actual question?

Read More
Doug -
July 10, 2012

Thank you for your question and I understand your concern.

This cook top has a re-ignition feature in which if the flame goes out it will spark until the burner re-ignites. Without gas connected and turned on this is why it sparks until turned off.

The burner that is not sparking could have a wire off the electrode or spark module.

I added a link to the Use and Care Guide and it states this on page 7.

Spark Module Removal Bottom Access

  1. Gain access to the bottom of the cook top.
  2. Remove screws securing spark module to access panel.
  3. Remove screws securing spark module to access panel.
  4. Disconnect and label wire leads from spark module. NOTE: Mark wires for exact replacement on module.
  5. Replace spark module and reverse procedure to reinstall.

Surface Ignitor Removal

  1. Remove screws securing burner base to orifice holder.
  2. Lift upward on burner base and disconnect ignitor wire.
  3. Remove screw securing ignitor to burner base.
  4. Replace ignitor and reverse procedure to reinstall.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
July 10, 2012
See more answers

Recommended maintenance parts & accessories

Show 3 more
No more item to show