Model #HCD-X1 SONY Receivers

  • Cabinet Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

garden tractor wont go model#917 25 1660- preparing to drain and fill the hydro transaxles,

A:

Thank you for your question.

I have looked up the parts break down of the transaxle the hole should be in the transaxle. In the image below, I have marked where the cutouts are. Please click on the image to enlarge it.

Please let me know if you have any other questions.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 15, 2011
A:

Thank you for your question.

I have looked up the parts break down of the transaxle the hole should be in the transaxle. In the image below, I have marked where the cutouts are. Please click on the image to enlarge it.

Please let me know if you have any other questions.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 15, 2011
See more answers
Q:

Broil does not work on Kenmore oven

A:

Thank you for your question and I understand your concern.

Based on your symptom and details, there is likely one of two possible failures preventing the broil element from heating. There is thermal fuse connected in a series circuit with one of the wires connected to the broil element. If the thermal fuse is open, the broil element will not heat. If the thermal fuse is good, it would have to be faulty electronic oven control board. NOTE: Be sure to disconnect the power supply from the range before removing the rear panel.

I suggest locating the disconnecting the thermal fuse and measure it for continuity. You will likely find it open meaning measuring no continuity. Set the Ohm meter to RX1 when measuring the thermal fuse for continuity. Remember to disconnect the two wires from the thermal fuse before checking the thermal fuse for continuity.

The thermal fuse is located behind the oven. It will have a blue wire with a white stripe and red wire connected to the thermal fuse. I added an image below of the wiring diagram along with a strip circuit of just the broil element circuit.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
October 10, 2012
Q:

Washer # 11045081404. 4"x6" rubber vibration dampers fell off. Where do they go? Why no part number?

A:

The sound dampening pads are usually placed on the center of the inside of the side panels in the cabinet. I am not aware that the HE4t model originally had these dampening panels installed. If not, they could have been added to reduce noise or vibration when the washer was serviced by a technician. They are not available as a replacement part. I recommend that you remove them and don't replace them. They were likely in place to reduce noise. They are not essential to the operation of the washer. The washer will not likely be that much louder without the sound dampening pads. If the sides of the washer begin vibrating (or oil canning), you may need to install the pads again. You may find adhesive residue in the areas of the cabinet where they were installed. You can glue them back in place with a strong silicone adhesive if necessary.

Read More
Lyle W -
Sears Technician
September 25, 2009