Model #GR9SHMXLB01 WHIRLPOOL Top-Mount Refrigerator

  • Cabinet/literature
    3 Results
  • Liner
    3 Results
  • Shelf
    3 Results
  • Refrigerator Door
    3 Results
  • Unit
    3 Results
  • Ice Maker
    3 Results
  • Freezer Door/optional
    3 Results
Find part by diagram >


Error Codes

Error Code:



Question and Answers


What should I do in order to remove a jammed ice cube in my ice maker?


It's easier to remove the ice maker assembly and let the ice maker thaw out. I added an image of your ice maker in order to reference the key# for the location of the screws.

To remove the ice maker from the freezer:

  1. Loosen the two (2) 1/4 inch hex head screws (key#39) located above the ice mold about 2-3 turns.
  2. Remove the one (1) screw (key#36) completely located below the ice mold.
  3. Raise the ice maker up 1/4 inch so that the ice maker can be pulled over the head of the two (2) upper screws and away from the side wall.
  4. Disconnect the ice maker wire harness (key#32) from the rear panel.
  5. Remove ice maker from the freezer and let it thaw out until the ice becomes free of the mold.
  6. Reverse the procedure to re-install the ice maker.
  7. The ice maker will begin making ice again after several hours.

Read More
Joey S -
Sears Technician
September 10, 2008

Top Parts