Model #GLGR331AS1 FRIGIDAIRE Residential Dryer

  • Dry Cab,heater
    3 Results
  • Frnt Pnl,door
    3 Results
  • Control Panel
    3 Results
  • Motor,blower
    3 Results
  • Burner,valve
    3 Results
  • 134054800 Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


How do you replace an ignitor, in step-by-step instructions, on a Frigidaire dryer model GLGR331AS1?


To replace the ignitor you will first unplug the dryer from power.

With the dryer unplugged you can use a putty knife to push in on the front clips and raise the top of the dryer.

With the top up locate and remove the two screws holding the top of the front panel to the cabinet. With the screws removed the front panel can be pulled out and up to release. The 1st image should help with this.

At this point you well see the burner assembly and ignitor. The ignitor is held on by one screw and a tab. The 2nd image below may help you with this. It would be better to change the ignitor at this point without any further tear down.

For better access you can remove the belt and drum. The 3rd iamge shows how to access the belt from the rear. The drum can be pull straight up and out of the rear bearing. With the drum out you will have access to the ignitor.

I hope this information helps you with this project but submit another question with any additional details for further assistance.

Read More
Fred M -
Sears Technician
February 24, 2010

how do you change the belt?

Read More
Stuart -
December 11, 2014
See more answers

Top Parts