Model #GGW9250PW3 WHIRLPOOL residential dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
  • 8576353 Burner Assembly
    3 Results
  • Door Parts, Optional Parts (not Included)
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

whirlpool duet dryer control lights work but doesnt run, just beeps.

A:

Thank you for your question.

If the dryer will not start on any cycle selected and only beeps 3 times generally indicates the door not shut completely or the door switch has failed. Make certain the door is fully shut. If the door is fully shut and it only beeps 3 times when start is pushed then the door switch and door switch circuit will need to be checked. The door switch can be tested using an OHM meter. Disconnect the WHITE and BLUE wires from the door switch before testing across the two terminals of the switch. The switch should measure continuity across the two terminals that the White wire and Blue wires were attached when the plunger is pushed in. If the door switch does not measure continuity, replace the door switch. I added an image below with instructions on how to remove the door switch. NOTE: Disconnect the power cord from the power source before access and testing the door switch.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
November 16, 2011
Q:

whirlpool duet dryer control lights work but doesnt run, just beeps.

A:

Thank you for your question.

If the dryer will not start on any cycle selected and only beeps 3 times generally indicates the door not shut completely or the door switch has failed. Make certain the door is fully shut. If the door is fully shut and it only beeps 3 times when start is pushed then the door switch and door switch circuit will need to be checked. The door switch can be tested using an OHM meter. Disconnect the WHITE and BLUE wires from the door switch before testing across the two terminals of the switch. The switch should measure continuity across the two terminals that the White wire and Blue wires were attached when the plunger is pushed in. If the door switch does not measure continuity, replace the door switch. I added an image below with instructions on how to remove the door switch. NOTE: Disconnect the power cord from the power source before access and testing the door switch.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
November 16, 2011
Q:

Whirlpool Gas Dryer

A:

Due to the nature of this failure involving gas, I recommend that you shut off the gas supply to the dryer. I also recommend that you contact a professional that is authorized to work with gas repairs in your area to identify the source of the leak.

Read More
Lyle W -
Sears Technician
September 22, 2011

Top Parts