Model #FDB1050RES2 FRIGIDAIRE Dishwasher

  • Control Panel
    3 Results
  • Door
    3 Results
  • Tub
    3 Results
  • Motor & Pump
    3 Results
  • Frame
    3 Results
  • Racks
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

My frigidare dishwasher quit working.

A:

Thank you for your question and I understand your concern.

Even though you found no tripped circuit breaker for the dishwasher circuit; the voltage supply will need to be checked and confirmed where it connects to the two door switches. The voltage supply should be checked across P2-2 (the Black wire with white stripe) and P2-9 (the solid White wire) at the control board. When the door is latched, there should also be 120 volts across the Black wire at P2-3 and the 2 White wires at the door switch. I added an image below of the wiring diagram. NOTE: If you do not have experience and you don't feel safe and confident in checking the voltage supply; I highly recommend calling a service technician to diagnose and repair your dishwasher. If there is no voltage at the control board or door switches; the wiring connections and voltage supply will need to be checked at the dishwasher junction box where the power supply connects to the dishwasher.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
November 04, 2011
Q:

Top washing arm of Frigidaire Dishwasher not getting water or spraying. What do I check?

A:

Thank you for your question and I understand your concern.

The upper and lower spray arms will never spray at the same time. The upper and lower spray arms alternate operation. It will always begin spraying out of the lower spray arm until the timer pauses the motor for one or two seconds at which time it will spray out of the top spray arm. The check ball will be at the bottom of the ramp when the dishwasher starts. If the check ball is stuck at the bottom of the ramp, it will never spray out the top spray arm.

I added an image below that will explain how this is done.

If you open the door and shut the door to check to see if the upper arm is spraying, it will revert back to the lower arm every time. Whenever the pump motor pauses too long or is stopped, the ball will roll back down the ramp blocking the port to upper spray arm. The information in the image below will explain in more details.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
December 21, 2012
A:

Robin: I'm happy I was able to help. Thank you for using Manage My Life and Merry Christmas to you and your family.

Read More
Joey S -
Sears Technician
December 23, 2012
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show