Model #F5887-920 HOOVER Power Steamer

  • Recovery Tank/handle
    3 Results
  • Hood/main Body
    3 Results
Find part by diagram >

Question and Answers

Q:

Singer Futura II 920...Where can I find the accessory kit and optional feet for it?

A:

Thank you for you inquiry.

The accessories that came with your Singer Futura II 920 sewing machine are no longer available as a complete set.

  • There are about 30 different accessory pieces still available as individual purchases from your local Singer Sewing Center, if you know what you are looking for. I would suggest looking in your local yellow pages for your local dealer and ask him to show you what is available.
  • You may also look on the Web by searching for Singer Futura II 920 accessories. You may find someone who is either selling the complete machine or just selling the accessories.
I hope this helps.

Read More
Sam A -
Sears Technician
July 28, 2010
Q:

Singer Futura II model 920...How do i change the outer belt and where can I get a new one?

A:

Thank you for your question on the Singer Furtura II 920. There are a couple different versions of the this model and I will need to know if the belt you are referring to is a belt that goes directly from the motor to the hand-wheel or if the is a idler cogged pulley and looks like is has a bent elbow pattern.

Please let me know the model you have.

Sam A.

Read More
Sam A -
Sears Technician
April 07, 2012
A:

Thank you Sandy, for the update on the sewing machine. Does the motor make any noise when you push the foot pedal? If the motor runs but the drive wont move then I would think it is the belts of stretched belts that could be adjusted. If the motor does not run when you push the foot control it will require diagnosing whether it is the foot control or the motor or some electrical problem in the wire harness. Please give me a little more detail so we can find the root of the problem. Sam A.

Read More
Sam A -
Sears Technician
April 09, 2012
See more answers
Q:

Singer Futura II Model 920: Needle will not pick up the bobbin thread, Why? Bobbin case is not turning when foot pedal is pressed, Why?

A:

Thank you for your question.

This machine has a shuttle type wind in place bobbin. Make sure it is reset to the sewing mode, before proceeding with the information below.

  • It is possible that the shuttle race driver bevel gear is broken and it will not drive the shuttle hook to pick up the thread.

  • To check to see if this is the problem you will have to remove the bottom cover of the machine. Remove the foot control and power to the machine.

  • Lay the machine on its back.

  • Remove the 4 screws on either end of the bottom cover with the rubber feet. And then remove the center screw.

  • Check the under side of the shuttle assembly and look at the two bevel gears that drive the bobbin assembly. If either one of the gears are broken, they will need to be replaced. I would advise you to have this done by a sewing machine repair person.

If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears technician. Here is a link that will provide the nearest drop-off locations: Sears Home Services .

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
August 19, 2010