Model #EXEC JET 4072 IBM Printer

  • Top Cover
    3 Results
  • Exit Guide
    3 Results
  • Bottom Cover And Sensors
    3 Results
  • Lower Paper Feed
    3 Results
  • Left Side Frame
    3 Results
  • Upper Paper Feed
    3 Results
  • Feed Roll
    3 Results
  • Power Supply And Printer Board
    3 Results
  • Carrier Drive
    3 Results
  • Carrier
    3 Results
  • Ink Supply/purge Unit
    3 Results
  • Sheetfeed
    3 Results
  • Serial Interface Card (optional)
    3 Results
Find part by diagram >

Question and Answers

Q:

Jet pump

A:

Thank you for your question.

I can understand wanting to change the well pipes to a single drop.

The usual difference with single and double drop pipes into the well is the depth of the well.

The single drop well pipe is for a shallow well system where the water lift is 25 ft of less.

The double pipe drop is for wells that are deeper than 25 ft. and the jet package is at the bottom of the well where in the shallow well it is at the top.

You will need to determine if you have a deep well or shallow well, with the water less than 25 ft. down and that any water draw down you would not run out of water.

Please reply and I will be happy to help you further after you determine the well type.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
June 16, 2011
A:

It was brought to my attention that I did not answer you so I need to apologize to you that for some reason I did not get back with you. The pump if you have not already figured this out is that this pump will not work to push water that far and feed 10 sprinkler heads. You would need a 3 to 5 hp pump to adequately supply enough water for all those sprinkler heads. As it is you may be able to supply one head with about 22 psi at .5 gallons per minute,because of the lift and distance from the water supply. Sam A.

Read More
Sam A -
Sears Technician
July 13, 2011
See more answers
Q:

where does the small jet go?

A:

Thank you for you question.

I am sorry you are having a problem with the carburetor. I should be able to help you with the repair of the carburetor. I have posted the instructions for rebuilding the carburetor below. Click on the image to enlarge it. If you need further assistance, please let me know. I will be happy to assist you.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
September 13, 2011
Q:

hydroglass jet pump

A:

Thank you for your question.

I can understand you wanting to know why the pumps get hot and shut down.

Without the model numbers from the pumps I can only give you some general information.

What is the voltage you are operating these pumps under?

Are they a deep or shallow well installation?

Are they pumping any water?

Please reply with a little more information and I will be happy to help you.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
April 19, 2011