Model #E70 HORIZON Elliptical

  • Elliptical
    3 Results
Find part by diagram >

Question and Answers

Q:

What does the error code E70 on my Kenmore Front load washer mean?

A:

The link below will answer your question.

What does "E 70" mean?

Read More
Joey S -
Sears Technician
Q:

Kenmore Elite induction glasstop range gives error codes E30 & E70, plus it will only beep even after hard reset. What does each code mean, & why two error code

A:

The error codes E30/E70 implies the AC input voltage is too high.

NOTE: I do not recommend attempting to diagnose and repair your induction range or nor would I recommend attempting to check any voltages or components. Induction ranges are very complex electronic appliances.

I suggest calling a service technician to diagnose and repair your induction range. A technician would have to make the following checks listed below.

1. Measure the house voltage at the main incoming connections on the Filter Circuit Board, between terminals X1,X2 and X4,X5 the voltage should be 240 Volts AC ± 10%.

2. Inspect electrical jumpers from X1 to X2 and X4 to X5.

3. Terminal X6 is your chassis ground wire.

4. If proper voltage is present, replace the Filter Circuit Board.

Call Sears at 1-800-4MY-HOME or 1-800-469-4663 to set up a service appointment.

Read More
Joey S -
Sears Technician
November 09, 2010
A:

Zborgerd: The E30 fault code implies improper power supply (Too High) . It's likely due to the higher than normal voltage.

Read More
Joey S -
Sears Technician
February 06, 2011
A:

Joe: It sounds like Zborgerd can provide the information your looking for.

Read More
Joey S -
Sears Technician
October 30, 2012
A:

Joe; The link below is of the part diagram from Sears Parts Direct and it has the wiring diagram. I do not have a service manual showing how to remove the top. http://www.searspartsdirect.com/partsdirect/part-model/KENMORE-ELITE-Parts/Range-Parts/Model-79045003803/0583/0124160

Read More
Joey S -
Sears Technician
October 30, 2012
See more answers
Q:

E70 error on my Kenmore front loading washing machine. it has something to do with draining or something, but can figure it out and dont have $160 for repair!

A:

Thank you for your question and I understand your concern.

As Joseph P. suggested; adding the model number would help in providing model specific information and specific troubleshooting assistance.

The link Joseph P. added in the first response may pertain to your model. If it doesn't; reply in the thread with the model number of your Kenmore washer for model specific troubleshooting assistance.

Read More
Joey S -
Sears Technician
August 17, 2011