Model #E-450LP WEBER Grill, Gas

  • Cabinet Assy
    3 Results
  • Side Burner
    3 Results
Find part by diagram >

Question and Answers

Q:

want to attach a 42inch craftsman bagger # 917.249791 to a 54inch craftsman tracto # 917.289900 I believe the diameter of the plastic tubes are the same

A:

Thank you for your question.I will be happy to assist you. I looked up the model numbers you submitted. The bagger will not work on your tractor. The mount is different and the lower chute will not match your deck. The correct bagger for your tractor is stock number 24917. The bagger can be ordered from the following link. Craftsman bagger model number 24917.  I hope this is helpful. Please reply below if you need further assistance.      Thank you for using Manage my life.Mark T.

Read More
Mark T -
Sears Technician
April 16, 2013
A:

evangelista, I do not think the bagger will work on the mower you are looking at buying. The reason is Murray only made a few mowers for Sears. The mowers they did make had a 43 inch mowing deck. The discharge opening on these mowers have a different opening than the 42 inch decks. If the bagger model number starts with 502 it may work. If it starts with 917. It will not fit. I hope this is helpful. Thank you for using Manage my life.

Read More
Mark T -
Sears Technician
June 25, 2013
See more answers
Q:

What does "E 70" mean?

A:

Without knowing the model number I can only provide general information.

I added a link below with information about the "E70" error code for Frigidaire branded front load washers and Kenmore branded washers that have a 417 prefix to the model number. An example Kenmore model number would be 417.xxxxxxxx.

Resubmit your question with the model number and any additional details for model specific information.

Why am I getting the E70 error code on my Kenmore front load washer?

Read More
Joey S -
Sears Technician
September 29, 2008
Q:

e 31

A:

I provided information about that E 31 code in the image below. I recommend that you have a service technician diagnose and repair this type of failure. Here is a link for the Sears Service website: Sears Home Services . There are many wires inside that cook top. Those wires need to be routed properly when the cook top is reassembled after the inside is accessed for service. If you open this cook top on your own, there is a chance that it may not work properly unless it is properly reassembled. If you are completely confident that you can shut off the house circuit breaker to completely disconnect electrical power and access the components, then you may be able to perform the troubleshooting that his shown below for that fault code 31. Be sure that you reassemble the cook top properly. If you need parts, you can order them from the Sears PartsDirect website.

Be sure that you completely disconnect electrical power to the cook top before accessing internal components and replacing parts.

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
November 25, 2011