Model #DU1100XTPS8 WHIRLPOOL Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >


Error Codes

Error Code:



Question and Answers


My Whirlpool dishwasher will not start. Cancel drain button flashes for a little while then goes off.


I'm sorry to hear that you are having some difficulties with your dishwasher. I did some research for you at and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to I hope these links provided assist you.

Read More
Barbara H. -
January 08, 2012

I know that it can be difficult to have your dishwasher stop working properly. Anytime the controls won't respond and there is a flashing LED light, it usually indicates that there is a shorted key and the control board needs to be replace. However, there is a service diagnostics test you can run to see if this is the problem. Within 6 seconds press these keys in this order.

Heated Dry - Normal- Heated Dry- Normal - Start

This will run through all the cycles to make sure they are working properly. If you can not enter the diagnostic cycle, then the board needs to be replace. If the cycle stops anywhere it will indicate what component is the problem.

If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
January 11, 2012
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show