Model #DLG2524W LG Residential Dryer

  • Control Panel And Plate Parts
    3 Results
  • Cabinet And Door Parts
    3 Results
  • Drum And Motor Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


i have an lg dryer i wont dry the cloth all it does is cool dry them can u help me with this?


A dryer is definitely something we depend on and when it begins to malfunction it can be a huge inconvenience. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question.

Read More
Yadira B -
October 17, 2012

it is a gas dryer

Read More
floyd leblanc -
October 17, 2012

It is upsetting when the dryer does not dry properly. The first items to thoroughly check are the vents. Verify there is no buildup in the vent or at the damper to the outside. A good check is to disconnect the vent from the back of the dryer while running a medium load of wet clothes. You can check the temperature at the back of the dryer with a thermometer. It should read between 120 to 150 degrees. If the dryer dries the clothes properly with the vent disconnected, then there is a restriction in the vent system. If the dryer is still not heating, reconnect the vent and check the igniter to see if it is glowing. Remove the small square plastic inspection cover located below and left of the door. Start the dryer and watch though the opening for a red glow of the igniter.

Do you see the igniter glowing? If the igniter is glowing and you hear a click from the flame sensor but there is no flame then most likely the gas coils or valve is bad. Make sure the gas supply is turned on. If there is not an issue with the gas supply you will need to test the valves. This would require a ohm meter. The image below provides information but I highly recommend having a technician make these checks and repairs. You can schedule a Sears technician here; Sears Home Services .

If you do proceed with these checks yourself, remember to disconnect power to the dryer.

If the gas valve checks good, then the operating thermostat, high limit thermostat or thermal fuse may be the problem.

If you need further help or information, please reply. Thank you for using Manage My Life.

Read More
Barbara H. -
Sears Technician
October 18, 2012

i have model dlg2524w. i noticed dryer does not get hot any more. i disassembled dryer. i configured dryer so that it powers on and runs. i noticed what i think is the heating element turning red and getting hot. fire started then after about 10 seconds the fire went out. what do you think it could be?

Read More
tony -
April 15, 2014
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show