Model #CWE5800ACB MAYTAG Built-In Oven, Electric

  • Control Panel
    3 Results
  • Oven (cwe5800acb/ace)
    3 Results
  • Body (cwe5800acb/ace)
    3 Results
  • Door
    3 Results
  • Door-lower (cwe5800acb/ace)
    3 Results
  • Wiring Information
    3 Results
Find part by diagram >

Question and Answers

Q:

control board replacement CWE5800ACB Maytag Oven

A:

Thank you for your question and I understand your concern.

The lower oven is controlled by a mechanical thermostat but the upper oven is controlled by the electronic oven control.

It would be unusual for both broil and bake elements to quit heating at the same time unless it lost line two (L2) voltage. I added an image below of the wiring diagram and I traced the bake and broil circuits in Red, Yellow, Purple and Black. The (L2) circuit is the one traced in Red. The red wire could have a loose and burnt wire connection at the terminal block where the incoming power supply connects in the oven. The bake and broil elements require line 1 (L1) and line 2 (L2) voltage. If the voltage measures 220 volts when measuring across the line one and line two voltage supply at the terminal block and there are no burnt or loose wire connections, I would have to suspect a faulty electronic oven control board. Before ordering and installing the oven control board I would make sure the voltage supply and the wiring is Okay. NOTE: I do not recommend measuring voltages unless you have experience and feel safe and confident in doing so; otherwise I strongly suggest calling a service technician to diagnose and repair your oven.

To access the oven control; remove the screws along the top of the front extrusion. Remove the knobs, switch nut, control glass and the screws at each side and top of the support bracket.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
November 20, 2012

Top Parts