Model #CTD-365-70692 Dcs counter unit, gas

  • Cooktop
    3 Results
  • Structure Components
    3 Results
  • Electrical Components
    3 Results
  • Gas Train
    3 Results
  • Wiring Diagram
    3 Results
  • Wiring Schematic
    3 Results

Question and Answers

Q:

maytag wall oven fault codes

A:

It is difficult to determine the exact cause of your F2 and F5 codes in the Maytag wall oven without a specific model number. These codes normally indicate that you have a bad oven temperature sensor probe or a failed electronic oven control board.

If you reply with the full model number and serial number of your Maytag oven, we will be glad to provide you with specific troubleshooting tips that may help you fix this failure yourself.

Read More
Lyle W -
Sears Technician
November 12, 2010
A:

I did not find information on a Maytag wall oven model CSW4800ACB. I recommend that you recheck that model number. On a wall oven with a similar model number, the F2 indicates a temperature sensor or control board failure. The F5 normally indicates the same type of problem. The problem that you are describing can normally be fixed with a do-it-yourself repair. Recheck that model number and reply with an update. We will assist you further once we receive more information.

Read More
Lyle W -
Sears Technician
November 15, 2010
See more answers
Q:

Uneven cooking with new KitchenAid 30in double oven gas range

A:

Here are some tips that may help you resolve this problem:

  1. Make sure that the range is properly leveled (especially side to side based on your description of the uneven temperature problem).
  2. Unplug the range and pull out the bottom oven panel (see image below). Remove the flame spreader over that bake burner in the bottom oven. Check the alignment of that burner. Check for any spills that may be blocking the gas ports on the left side of that burner. Clean the burner if necessary. Reassemble the bottom of that oven. Make sure that the flame spreader and the bottom panel are properly installed.
  3. If you are not using the convection baking mode, I recommend that you try using that feature when baking cakes and other items. That convection fan should circulate the air in the oven for more even heating.

If you still have problems with the oven heating properly after following these tips, I recommend that you have the range serviced by a technician. Here is a link for the Sears Service website: Sears Home Services .

NOTE: Even if a technician visits your home and examines the oven, there is no guarantee that this type of temperature variance inside the oven can be completely eliminated. There will often be some reasonable temperature differences inside the oven cavity. Keep this in mind if some of the tips provided above help to minimize that temperature variance to a point where you can use the oven for the cakes.

If you need more help, let us know.

Read More
Lyle W -
Sears Technician
November 16, 2011
Q:

Defective theermostat on oven

A:

That phone number that Chat in RI posted above is correct (1-800-469-4663). Call that phone number to arrange the maintenance check up on your protection plan.

Read More
Lyle W -
Sears Technician
October 23, 2012