Model #CL 37E56 TOSHIBA Direct View\Digital 27" to 40" TV

  • No Image Available - Wards
    3 Results
Find part by diagram >

Question and Answers

Q:

Why won't my dishwasher advance or "CL"?

A:

Without the model number of your dishwasher I will not be able to provide any model specific information. The time in the display window is not a clock timer, it's the estimated time. The time can stall out while the water is being heated up to a minimum set temperature. If the heater is not working due to several different possible failures the dishwasher will not advance on. It could have control board failure or other component failures. "CL" will not display if the dishwasher will not complete the cycle.

This type of dishwasher will require a technician to diagnose and repair. I recommend calling a service technician to diagnose and repair your dishwasher.

Read More
Joey S -
Sears Technician
Q:

Frigidaire dishwasher Flasher CL

A:

Hi Jeremy,

Thank you for submitting a question to Manage My Life.

I am sorry you are having problems with your dishwasher.

This is an issue I have seen quite often. You mention that the door switch is good but at some point in the cycle the door switch stops making contact. The dishwasher will continue to run when the cycle was momentarily interrupted.

Here is a link that you may use to purchase the Door Latch .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

If I may be of further assistance as more details become available, please reply to this post.

Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
June 13, 2011
A:

Hi Jeremy, According to the information we have this issue is caused when the control board sees the door switch as open. If you still get the same error with the door switch jumped, you will need to check the wiring and connections. Sometimes when dealing with electronics we have to use the process of elimination. There are no checks that we can perform to check this function of the control, we can just test the door switch and wiring. If they seem to be functional then one must assume it is a control issue. With that being said, be sure the door switch does not intermittently loose connection with functional vibration. Then, I recommend ohming the wires between the control and door switch. I have included a link below that you may use to purchase parts if needed. I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. Thanks again for using Manage My Life. Landell

Read More
Landell -
Sears Technician
June 14, 2011
See more answers
Q:

For Kenmore Elite washing machine, how do I disengage the Control Lock (CL)?

A:

Thank you for your question and I understand your concern.

Press and hold the CONTROL LOCK button for 5 seconds to Lock or Unlock the controls.

I added a link to the Use and Care Guide and on page 22 it will have the information the Control Lock function.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

 

Read More
Joey S -
Sears Technician
September 30, 2013