Model #CK-2553B MITSUBISHI Direct View\Digital 27" to 40" TV

  • No Image Available - Fidelitone
    3 Results
Find part by diagram >

Question and Answers

Q:

Ck motor module on ice maker

A:

Here is a link for a video that shows how to remove that type of ice maker from the freezer: Video: Whirlpool Ice Maker Repair .

Here is a link for a previous answer that provides extensive technical troubleshooting for the ice maker system on this type of refrigerator: How do I get my icemaker to work? There is no ice/water in the system anywhere. .

This information should help you with your repair. If you need more assistance, reply with additional details based on the information provided above.

You can order parts from the Sears PartsDirect website.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
August 03, 2011
Q:

Need to change pully on kenmre dryer, and ck drive belt

A:

In order to access the belt, motor and idler pulley the top must be raised and the front panel removed. Remove the lint filter and remove the screws that were hidden by the lint filter. Hinge the top open by releasing the two clips as shown in the image below using a putty knife and lift the top. Remove the screw located at the top of each side panel and then pivot the front panel towards you and disconnect the door switch. Lift the front panel up and off. You now have access to the idler pulley, motor and belt.

Read More
Joey S -
Sears Technician
May 03, 2010
Q:

how do get to the coupler and or water pump, for Washer Model 110.20802990, SER CK 1437259

A:

Thank you for your question.

I am sorry you are having a problem with your washer. I suspect the problem with the washer is a broken motor coupler. The coupler links the motor to the transmission instead of using a belt. When the coupler breaks, the washer will not agitate or spin and often will make an unusual noise. To verify the problem, I recommend starting the washer in a wash cycle. After the washer fills, check to see if the washer is agitating. If it is not, the motor coupler is likely the cause. The part number for the coupler is 285753A and can be ordered from our website Sears Parts Direct .

To replace the coupler unplug the washer first. Then use the images below to access the coupler. Use a screwdriver to pry off the rest of the old coupler. Then tap the new coupler onto the shafts with a deep well socket and a hammer. The parts of the coupler should be flush with the end of the shafts. Then reassemble the washer in the reverse order.

I have also found a video that will give you more confidence in repairing the washer yourself. Please click here to watch the video .

I hope this is helpful. Please let me know if you need further assistance.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
December 04, 2011