Model #C50XDDY0B047 KENMORE Attachments (Vacuum)

  • Power-mate
    3 Results
Find part by diagram >

Question and Answers

Q:

I have a Kenmore Canister Vacuum Cleaner Model 116.27515700 with a defective switch. I need some help to disassemble the Handle Assembly

A:

Thank you for your question.  I am sorry you are having a problem with the vacuum. I know the handle removing the handle can be difficult. I posted an image below that shows how to open the handle. Just click on the image to enlarge it. I also found a video that shows how to open the handle. Click here to watch the video. Here is a link to order any parts you need for the vacuum.   Sears Parts Direct .     If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears  technician.  Here is a link that will provide the nearest drop-off locations:  Sears Home Services . I hope this is helpful.  Please let me know if you need further assistance on the vacuum.  Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
February 20, 2013
Q:

How do I install the Motor Adjustment Spring and the Filter Intake/Exhaust in the Power Mate attachment to my Kenmore Progressive . Diagram?

A:

Thank you for your question.

I can understand wanting to have the instructions on the motor spring placement and the filters.

The filter just fit in the corners of and is captured between the two housing half’s.

The motor tension spring is not even used anymore but I will give you some pictures and instructions below.

The motor tension spring has the square end goes in the base slot with the round end against the motor foam cushion.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
April 18, 2011
A:

Thank you for your question on the replacement of the spring. The version of power mate I have does not have the air filters I think you are referring too. I will give you a few more pictures of the motor and the tension spring location. With the motor out of the location install the long part of the tension spring into the slot in front of the motor and push down until it seats. Then with a little force position and push down on the motor and slide into position in the base. I hope this will help. Sam A.

Read More
Sam A -
Sears Technician
June 11, 2012
A:

I am sorry but the exhaust foam is no longer used in production on these units. In fact they didn't even put it in the parts list right after the first production run of power mates so that is why you do not see it in the parts list. It is not a required part. I also would be concerned that it would get into the motor area and block air flow. Sam A.

Read More
Sam A -
Sears Technician
June 11, 2012
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show