Model #BV2000 TYPE 6 BLACK & DECKER Blower, Electric

  • Blower/vacuum
    3 Results
Find part by diagram >

Question and Answers

Q:

What type of oil do I need to change the oil in my Craftsman 12.5 hp 6 speed, 38" deck.

A:

The model number you sent is for the engine. The model number of the mower is under the seat. The information you sent is all we need to answer your question, but if you ever need parts you need the model number of the mower.

The engine in your riding mower is 30 weight motor oil. Use a name brand good quality oil and it will be fine.

Read More
Jimmy K -
Sears Technician
June 05, 2009
Q:

I just bought a Kenmore elite toaster model No. 100.90003. The cord is about 6 inches too short. What type of extension cord should I buy? i.e. amps/volts.

A:

You can use an extension cord for the toaster if the cord has 2 wires and three prong outlet and receptacle. The cord should have number 14 wire to carry the load of the toaster. Number 14 wire will carry 15 amps.

Read More
Jimmy K -
Sears Technician
April 02, 2010
Q:

My kenmore elite washer will not spin during the spin cycle

A:

If the washer stops completely and will not spin or drain the water, then you could have a bad lid switch as described in the link for a previous answer that James R. provided in the above response. The first image below shows how to open the cabinet of this washer to access that component. I recommend that you unplug the washer and place an insulated jumper wire in the lid switch harness as shown in the bottom of the image. Reassemble and test the washer. If it spins with the lid switch bypassed in this manner, then replacing the lid switch will fix your problem. You can order a new lid switch from the Sears PartsDirect website. The part number is 8054980. Here is a direct link for that part: Lid switch .

If the washer drains the water but does not spin, you can check to see if it agitates properly. If it does not agitate or spin but does drain the washer, then the motor coupler (part 285753A) is probably broken. The second image shows how to access this component.

If the washer drains and agitates properly, then you could have a bad transmission, a control board problem, a failed basket drive, a worn clutch or a number of other failures that could prevent it from spinning. The third image shows how to access the other components in the drive system. A service technician will normally need to diagnose and repair this type of problem unless you can use the information in the third image to access the components and find the failure.

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
December 30, 2010