Model #BT3000 RYOBI Saw Table

  • Unit Parts
    3 Results
  • Sliding Miter Table Assembly
    3 Results
  • Rip Fence Assembly
    3 Results
  • Motor Assembly
    3 Results
  • Blade Guard Assembly
    3 Results
  • Replacement
    3 Results
  • Blade Guard Assembly
    3 Results
  • Replacement
    3 Results
  • Table Saw
    3 Results
  • Sliding Miter Table Assembly
    3 Results
  • Rip Fence Assembly
    3 Results
  • Motor Assembly
    3 Results
  • Blade Guard Assembly
    3 Results
  • Replacement Parts
    3 Results
  • Metal Work Stand
    3 Results
  • Wide Table Kit
    3 Results
  • Long Miter/rip Fence Kit
    3 Results
  • Router/jig Saw Mounting Kit
    3 Results
  • Miter Clamping Kit
    3 Results

Question and Answers

Q:

installation of belt for Ryobi BT3000 table saw

A:

Thank you for your question.

 

I see that Anonymous  gave you link to the instructions for replacing the belt. Just click on the link to load the instructions. Be sure to unplug the saw and remove the blade before replacing the belt.

I hope this is helpful. If you need further assistance, please reply below with more details.

 

Thank you for using Mange my life.

 

 

Mark T.

Read More
Mark T -
Sears Technician
August 12, 2013
Q:

Craftsman Table Saw Parts

A:

I see that shim part 969599-001 that is listed as a replacement shim part for Craftsman Table Saw 315.228110. It is shown as Key 86 on the parts diagram in the manual (circled in red on the image below). Here is a link for the full owner's manual on that saw: Craftsman Table Saw 315.228110 Manual . The parts diagram is on page 48 of that manual. Here is a link for that part 969599-001 on the Sears PartsDirect.com website: Shim for Craftsman Table Saw 315.228110 . According to your details, it sounds like that part is the same as the one on the Ryobi BT3000 saw. It is the same key number on the parts diagram and the same part number. That parts webpage that I provided above has a photograph of that part. You should be able to use either part. That component should be identical no matter which source it is ordered from.

I hope that this information helps. If you need more assistance, let us know.

Read More
Sam A -
Sears Technician
June 27, 2012
A:

Hello! Mike: I have been out for a funeral leave and just got back and Lyle ask me if there was some better fix for this BT3000 Ryobi built table saw for the shim replacement. I am sorry but the manufacturers suggestions is to keep that area as clean as possible and when you need to replace the shims, is to replace both sets at the same time. I am sorry that I do not have any better fix than that. Sam A.

Read More
Sam A -
Sears Technician
June 27, 2012
See more answers

Top Parts