Model #BP-250 HOMELITE blower, gas

  • Figure 1
    3 Results
  • Figure 2
    3 Results
  • Figure 3
    3 Results
  • Carburetor - Walbro Wt-150
    3 Results
  • Carburetor - Zama C1u-h13
    3 Results

Question and Answers

Q:

i have a poulan bp 406 leaf blower.When i give it gas it shut down

A:

Thank you for your question.

I am sorry you are having a problem with the blower. If the fuel mixture in the blower is older than 5 weeks old, it should be drained. Then refill with fresh fuel mix. If this does not help I suspect there is a problem with the fuel system. I recommend checking in the fuel tank first. When you look in the tank, you should see a fuel line with a white filter attached to the end. Then inspect the fuel line. If it is hard and brittle, it has to be replaced. If the fuel line is fine, I suspect the carburetor is to blame. The carburetor will have to be cleaned or replaced. Here is a video that show how to clean the carburetor. Before you remove the carburetor, make sure to note the fuel line and cable connections. This will save a lot of frustration later.

Here is a link to order any parts you need. Sears Parts Direct .

I hope this helpful. If you need further assistance, please reply below with more details.

If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears technician. Here is a link that will provide the nearest drop-off locations: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
December 20, 2011
Q:

My oven does not go pass 250

A:

Thank you for your question and I understand your concern.

In order to provide any model specific information, I will need to know the model number of your range or wall oven.

Based on your symptom, if this is a gas range, the failure could be the glow bar bake igniter. If it's an electric range, it could have a faulty electronic oven control.

So that’s what I can tell you at this point. I can give you more detailed help if you could provide me with the complete model number. The model numbers are typically located on the oven frame somewhere around the oven cavity opening or it could be on the oven frame behind the broiler or storage drawer. If you could supply me with that information I will be happy to assist you further. 

Read More
Joey S -
Sears Technician
November 09, 2013
Q:

Kenmore ultrasoft 250 water softner

A:

Thank you for your feed back on the water softener control plug.

I am sorry that you had gotten it reversed and that is a good comment about making the wire harness plug only going on one way.

Thank you for your comments and I am glad that you got the water softener showing water flow again.

Sam A.

Read More
Sam A -
Sears Technician
August 15, 2012