Model #BD-1025VR RYOBI Drill Driver

  • Cordless Driver Drill
    3 Results
Find part by diagram >

Question and Answers

Q:

oven too hot 675

A:

Thank you for your question.

I can understand wanting to replace the control because of the high heat.

To replace the control:

First REMOVE POWER to the range.

Pull the range out from its location and locate and remove the screws that secure the upper back cover panel.

Once you have the panel removed, locate and remove the four screws that secure the electronic control to the control panel.

With the other control in hand replace connector for connector one at a time and any loose individual wires if it has any. (mostly they should be plug in connectors)

Once you have the wiring changed to the new control, then re-install the control in the range control panel and re-install the back panel and restore power to the range.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
April 12, 2011
Q:

had code 42 replace control bd but now not locking door just start flashing

A:

Without having a model number and more information, I would have to say yes, you have a bad door lock assembly if you just replace the control and the door won't lock. You can unplug the washer and check the wire harness connections before replacing the door lock assembly. If the wiring connections are okay then you may need to replace the door lock assembly. If you want us to provide more technical information that may help you verify this failure, submit additional details including the full model number of your washer.

Read More
Lyle W -
Sears Technician
July 16, 2010
Q:

I have a Sears 1/2 HP Pump Model 390.252151. The instruction manual for installation is in error. On page 8 B-D.

A:

I don't have a breakdown of the motor to look at, but I think the motor canopy will be on the rear of the motor. The motor canopy will be covering the rear shaft of the motor.

It seems that this section might be out of place. The reason you need the 7/16 wrench to hold the motor shaft is so you can unscrew the pump impeller from the motor shaft.

Before you can remove the tank body back half, you have to separate the pump halves. You must remove the impeller from the motor shaft and remove the pump seal on the back of the impeller.

The spring tension you feel is because the impeller and seal are still on the motor shaft. When you remove the parts of the pump, the back half will easily pry off the motor.

The instructions for removing the impeller seem out of place but complete.

When you get the impeller and seal off the motor shaft, the back half will pry off the motor.

We are not allowed to call customers, I hope this helps.

Read More
Jimmy K -
Sears Technician
June 11, 2009