Model #AO-27DB-P85547-4S AMANA Built-In Oven, Electric

  • Glass Door
    3 Results
  • Door Latch Assembly
    3 Results
  • Cabinet Section Single Oven (ao-27sb/p85547-3s) (ao-27sb/p85547-5s)
    3 Results
  • Cabinet Section Double Oven (ao-27db/p85547-4s) (ao-27db/p85547-6s) (ao-27db/p85547-8s)
    3 Results
  • Control Panel Section
    3 Results
  • Control Compartment Section
    3 Results
  • Oven Accessories (ao-27sb/p85547-3s) (ao-27db/p85547-4s) (ao-27sb/p85547-5s) (ao-27db/p85547-6s) (ao-27db/p85547-8s)
    3 Results
  • Control Panel Section (ao-27sb/p85547-7s)
    3 Results
Find part by diagram >

Question and Answers

Q:

Head rebuild Air compressor #919155731

A:

Thank you for your question on the air compressor rebuilt.

I believe you should have gotten a head and reed valve plate and some gaskets. This should be all you need to update the head and reed plate assembly repair.

You should not need the flat head gasket or the round O-ring for the cylinder.

Sam A.

Read More
Sam A -
Sears Technician
August 08, 2012
Q:

craftsman compressor

A:

Thank you for your question on the wiring positions on the GE motor.

There should be a motor number on the side of the motor on a sticker. It should start with a MOXXXX number.

I will send you the one for GE motors that I have.

It should work for most GE air compressor motors.

If it is not right then please reply with the motor number and I will try to get some information on the motor wiring.

Sam A.

Read More
Sam A -
Sears Technician
October 17, 2012
Q:

Are heating elements at my local hardware store usable in my Kenmore Power Miser water heater?

A:

The elements in Kenmore water heaters are different. Kenmore water heaters will have elements with a 1 3/8" thread instead of the standard 1.25" threads. Our local Ace Hardware store has them, or you can order them online. Likely if you are changing a bottom element you will need to clean the minerals out of the bottom of the heater once the element is out. If you have had a functioning water softener you can simply remove the old unit and replace it with a new one. Any 1 3/8" element from 3500 to 4500 watts should work fine in the bottom or top element placement on your heater. The bottom element normally goes out first, either because of mineral build-up or just because it works more often.

Read More
Lyle W -
Sears Technician
April 06, 2009