Model #AIR-SA10 SONY Speakers

  • Cabinet Parts
    3 Results
  • Top Panel
    3 Results
  • Front Panel
    3 Results
  • Rear Panel
    3 Results
Find part by diagram >

Question and Answers

Q:

air leak on air compressor

A:

Thank you for your question.

I can understand how the leaking of air on the pressure relief can be a concern.

If some cases if you did not cut the old pressure relief pipe off and used the new nut and ferrule on the new pressure switch it could be the cause for the leaking.

On some models I have seen that the check valve on the tank where the pressure relief tubing starts from is bad. It bleeds air back from the tank to the pressure switch, instead of just unloading the tubing from the compressor head.

The problem could be the tank check valve and not the pressure relief unloader on the switch.

I have seen though it is rare that the new switches could be out of calibration with the lever being too close to the relief valve pin.

If this is the case I would suggest that you reform the tab lever to not put pressure on the relief valve pin during run time of the compressor.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
December 02, 2010
Q:

portable air air compressor

A:

Thank you for your question on the portable air compressor with the lubricant leaked out.

Well,that is not a good sign to have all the oil leak out.

I would suggest removing any oil that is left and removing the front cover to see if you can turn the crankshaft by hand.

If it is seized then you may want to consider a new one.

If you would please reply with the model number of the unit I may be able to let you know if you will be able to rebuild or if it would be better to replace it.

Sam A.

Read More
Sam A -
Sears Technician
July 25, 2012
Q:

air conditioner

A:

One or both of the pc boards on the air conditioner was probably damaged by the thunder storm. These boards are items 71 and 72 on page 2 of the parts diagram.

I suggest you get a Sears technician to diagnose the failure and replace the damaged part or parts.

Read More
Jimmy K -
Sears Technician
June 17, 2010