Model #970-C98902-00 Sears Canada laundry centers/combos

  • Upper Cabinet
    3 Results
  • Motor/blower/belt
    3 Results
  • Control Panel
    3 Results
  • Lower Cabinet/top
    3 Results
  • Motor/tub
    3 Results
  • Transmission
    3 Results
  • Wiring
    3 Results

Question and Answers

Q:

What is a self-cleaning lint filter in my Kenmore washing machine? Do I ever have to remove lint from my machine?

A:

Thank you for your question on the self-cleaning lint filter for your Canadian built laundry center.

The model number of this model is 970.C98902-10.

It has a self cleaning filter under the agitator build into the spin basket.

You would have to remove the agitator to gain access to the filter but it is part spin basket and it is designed so that you do not have to clean it.

As the spray rinse water for the cycle flows into the tub during spin it flushes out any lint build up.

I hope this will help answer you question.

Sam A.

Read More
Sam A -
Sears Technician
August 09, 2012
Q:

Kenmore Electric Range , model 970

A:

Thank you for your question and I understand your concern.

One of the surface element control switches is faulty. On each of one of the surface element control switches is a terminal with a wire connected labeled (P). When the switch is turned on, the terminal (P) will supply voltage to the "Element ON" indicator light. You can narrow down which switch is faulty by turning the power supply off to the range and then accessing the burner switches and pull the wire connected to terminal (P) off. Position the wire so it does not touch any other terminals or ground and then re-apply power. If the "Element ON" light does not come on; replace that switch. If it comes back on; disconnect the power supply off and re-install the wire and then take the wire off the next switch from terminal (P) and continue the steps until you find the faulty switch.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post along with the complete model number.

Read More
Joey S -
Sears Technician
July 24, 2012
Q:

Husqvarna mower Rider 970 does not go forward

A:

Thank you for your question on the Husqvarna riding mower forward motion pedal not working.

If you look under the seat of the rider you should see two model numbers on the model serial tag. One should start with an YTHXXXXXX (it should have the horse power and the deck width in the number) and the other one should start with a 960XXXXXXX.

Please look for these number and reply and I will be happy to help you.

Sam A.

Read More
Sam A -
Sears Technician
September 27, 2012
A:

Thank you for the update on the riding mower. This is a cool little rider with both the front and back wheels the same size. I found a sight that shows the parts breakdown and it has a cable on the left and one on the right. The left cable as you sit on the tractor is 506 82 72 -01 and the right cable is 506 96 02-01. If the left cable is the forward cable then you are correct. I have added a link below to parts source for this tractor. I hope this will help. Sam A.

Read More
Sam A -
Sears Technician
September 27, 2012
A:

I am sorry but we are experincing internet problems right now so I was not able to find a sight that has the cable fro you to purchase. I will continue to try later. Sam A.

Read More
Sam A -
Sears Technician
September 27, 2012
See more answers