Model #95-1962-23-00 Tappan top-mount refrigerator

  • Cover
    3 Results
  • Door Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Shelves And Supports
    3 Results
  • Shelves And Supports
    3 Results
  • System And Automatic Defrost Parts
    3 Results

Question and Answers

Q:

1962 evinrude no spark

A:

Thank you for your question on the old Evenrude outboard motor.

On the transom plate there should a model number for this unit.

Please reply with that model number so I can research the information you are looking for.

You may also want to contact Iboats.com for some information but you will need the model number of the outboard.

website for outboard motor information .

Sam A.

Read More
Sam A -
Sears Technician
July 11, 2012
Q:

Where is the temp control on my 95 Kenmore freezer model 253.9155010?

A:

The image below shows the temperature control for this freezer. Key 18 is the control knob. Key 21 is the temperature control.

Read More
Lyle W -
Sears Technician
July 23, 2008
Q:

What would cause my dryer to take 2-3 cycles to dry?

A:

First, if your dryer is an electric dryer and not gas remove the vent hose from the rear of the dryer and dry a load. If it dries the clothes in one cycle normally that would indicate a venting issue. Open the door and remove the lint filter and check for a blockage down in the lint filer housing. Inspect the lint filter, take the filter and run water over it to see it the water will pass freely through it. If you use fabric softener it will leave a clear layer over the little holes and restrict the airflow. Take the lint filter and wash it off with water and a brush. Use a vacuum to clean the lint out. Any airflow problem will cause the dryer to take longer to dry. If it's a gas dryer it could have weak gas solenoid coils and it's not always opening the gas valve.

If you’re confident that there are no air flow restrictions I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
July 16, 2008