Model #95-1522-23-00 TAPPAN Top-Mount Refrigerator

  • Cover
    3 Results
  • Door Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Shelves And Supports
    3 Results
  • System And Automatic Defrost Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

My treadmill circuit breaker trips after 15-22 minutes of use. Do I just need a motor replacement?

A:

If the motor is not making a noise or sparking, it is probably ok. It is normal for the motor to get too hot to hold your hand on it.

The circuit breaker may be weak. Circuit breakers get weak if they are failing.

If the walking belt is worn or needs lubrication, it will cause the motor to draw more amps and heat more than normal.

Lift the walking belt on each side and look at the walking board. Check for wear on the walking board and belt by running your hand across both. If you feel any roughness or worn spots, that part needs replacing.

To test the walking belt lubrication, do not turn the treadmill motor on. Set the elevation to the highest level. Stand near the front of the walking belt. Push yourself firmly toward the rear of the treadmill. If the belt is properly lubricated the belt will take you to the rear edge of the treadmill and dump you off on the floor. If you move and stop, the belt needs lubricating.

The part number for the belt lubrication kit is 219168. You can buy it at [www.searspartsdirect.com]. The cost is around $4.00. The application instructions should be in the package, but in case they are not here is how to apply the lubrication.

Turn the walking belt until the belt seam is along the top of the front roller. Raise the belt on one side in the center of the walking board front to back as high as you can. Apply ½ the tube of lubrication to the walking board in a zig zag fashion moving from front to back. Move the belt until the seam comes up on top of the rear roller and lift the belt again and put the rest of the lubrication on the walking board in the same manner. Turn the treadmill on and walk on the belt for 10-20 minutes. Walk all over the belt to distribute the lubrication evenly on the walking belt and board.

Read More
Jimmy K -
Sears Technician
February 18, 2010
Q:

Where is the temp control on my 95 Kenmore freezer model 253.9155010?

A:

The image below shows the temperature control for this freezer. Key 18 is the control knob. Key 21 is the temperature control.

Read More
Lyle W -
Sears Technician
July 23, 2008
Q:

What would cause my dryer to take 2-3 cycles to dry?

A:

First, if your dryer is an electric dryer and not gas remove the vent hose from the rear of the dryer and dry a load. If it dries the clothes in one cycle normally that would indicate a venting issue. Open the door and remove the lint filter and check for a blockage down in the lint filer housing. Inspect the lint filter, take the filter and run water over it to see it the water will pass freely through it. If you use fabric softener it will leave a clear layer over the little holes and restrict the airflow. Take the lint filter and wash it off with water and a brush. Use a vacuum to clean the lint out. Any airflow problem will cause the dryer to take longer to dry. If it's a gas dryer it could have weak gas solenoid coils and it's not always opening the gas valve.

If you’re confident that there are no air flow restrictions I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
July 16, 2008