Model #93627-CB Peerless faucet

  • Replacement Parts
    3 Results

Question and Answers

Q:

how to fix fan

A:

Thank you for your question and I understand your concern.

The model number you provided is not a valid/correct model number. I will base my answer on a model FEB27S5GCB wall oven.

In order to access and replace the cooling fan, the oven will need to be un-installed. The top panel will need to be taken off to access the cooling fan. Once the oven has been pulled out, the two top panels can be taken off once the screws have been taking out securing the top panels. NOTE: Disconnect the wall oven from the power source before removing the top. Once the top has been taken off, you should see the cooling fan towards the rear. There will be a few screws to remove in order to take the fan out. Reverse the procedure to install the new one.

I added an image in second reply with the instructions for removing the wall oven.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
January 24, 2013
A:

Tammy: I added the instructions for removing the wall oven below.

Read More
Joey S -
Sears Technician
January 24, 2013
See more answers
Q:

Circuit Breaker requirement for new range

A:

Thank you for your question.

I can understand wanting to know what amperage the circuit breaker needs to be for this range.

Since this is a full size electric 240 volt range and not just a cook top it will require a 50 amp breaker.

My concern is that if you are using the same wiring for the range as you did for the cook top it may be to light of gauge wire to be a 50 amp circuit.

Most 50 amp circuits require an 8 gauge wire for the range circuit.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
February 17, 2011
A:

Thank you for the update. This gauge is certainly heavy enough it the local electrical code is all right with the Aluminum wire. Thank you for using Manage My Life. Sam A.

Read More
Sam A -
Sears Technician
February 17, 2011
See more answers
Q:

What would cause my dishwasher to not power up?

A:

There is a good possibility of the thermal fuse (TCO) has failed. In order to diagnose the failure will require disconnecting the thermal cut off (TCO) and checking it with an ohm meter for continuity. You will also need to check and confirm the voltage supply to the control board. I added an image below of the wiring diagram. This will show you will the power supply is connected to the control board. The control board needs to have 110-120vac when measured across P2-6 and P7 and 110-120vac when measured across P8 and P7. You locate the thermal fuse (TCO) by tracing the Black wire with a White stripe from the door switch. The thermal fused will be located on the edge of the circuit board housing. It will have a black and black wire with a white stripe connected to it. See image below. The thermal fuse is part #8193762. I added a link to Sears Parts Direct with the thermal fuse already looked up for you. Click on "Fuse" to open link. Use all the parts that come with the thermal fuse. NOTE: I do not recommend checking voltages unless you have experience and feel safe and confident in doing so, otherwise I recommend calling a service technician to diagnose and repair your dishwasher.

Read More
Joey S -
Sears Technician
November 09, 2009