Model #919176951 CRAFTSMAN Air compressor

  • Air Compressor
    3 Results
  • Compressor Pump Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

wiring D20659 220 electric motor 919176951 Craftsman Craftsman air compressor

A:

Thank you for your question.

 

 

I am sorry you are having a problem with the air compressor. The ground wire should connect to the green ground screw under the cover. If you do not have a green screw, please take a picture of the terminal connectors and post it below. Once I see the set up on your motor, I should be able to determine where to connect the ground.

 

I hope to hear from you. Please let me know if you need further assistance.

 

 

 

Thank you for using Manage my life.

 

Mark T.

Read More
Mark T -
Sears Technician
October 08, 2013
Q:

Craftsman Air Compressor #919176951: Thank for instructions to replace substitute pump assembly #N076027, it differant than original.

A:

Thank you for your question.

I am sorry you are having a problem with the air compressor. I have searched for information on the two pumps but did not find any information saying that modifications had to be made when installing the new pump. It looks like the substituted part should mount to the tank in the same manor as the original.

If the new pump will not mount the same as the old pump, please reply below with the details of what is different.

I hope this helpful. Please let me know if you need further assistance.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears technician. Here is a link that will provide the nearest drop-off locations: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 16, 2011
Q:

repair

A:

Thank you for your question on the replacement of the oil seal on the crankshaft.

This air compressor has a tapered crankshaft with a swedge fit between the pulley flywheel and the crankshaft.

You will need to have a 3 jaw puller if the fly wheel is tight to the shaft.

Before I went out to buy any tools I would remove the center bolt and washer that holds the pulley flywheel onto the crankshaft to test whether it is tight or not to the crankshaft. If it is you may be able to lightly tap on the flywheel hub to see if it will left go of the crankshaft. If not you will need a puller to remove it from the shaft.

Once you have the flywheel off you can either us a seal pick or remove the two bolts that holds the bearing and seal to the crankcase. If you do that you will need to drain the oil from the crankcase first.

Once you have the old seal out you can simply tap it in with a hammer around the outer edges of the new seal to install it.

I hope this information will help you.

Sam A.

Read More
Sam A -
Sears Technician
July 25, 2012

Top Parts