Model #91195575790 Kenmore free standing, electric

  • Backguard
    3 Results
  • Maintop
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Door Lock
    3 Results
  • Wire Harness And Components
    3 Results

Question and Answers

Q:

kenmore stove model 91195575790

A:

Thank you for your question on how to change the oven bake element in your range.

First REMOVE POWER TO THE RANGE.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Once you have the power disconnected to the range you can open the oven door and remove the oven racks.

Then locate the two screws at the back of the range and remove them.

Slowly pull the old bake element forward until you have access to the electrical terminals at the back of the element.

Remove the terminals and install the wires onto the new element and slowly push back into place.

Replace the screws that secure the element and the re-install the oven racks and check operation.

Please let me know how it went.

Sam A.

Read More
Sam A -
Sears Technician
October 08, 2011
Q:

Where can I find the wiring diagram for my Kenmore glass cook top model number 91195575790?

A:

Unplug the range and make sure that you carefully followed the instructions on wiring up the new element. The images below show the instructions that you should be following to wire up the new element.

If you are certain that you have the element wired correctly, then you could have a bad switch. Since both element coils heat properly when L1 and L2 voltage are applied to them, then the element should be okay. If you are not getting proper voltage from the switch, then it will need to be replaced. A technician is normally needed to conduct voltage checks from this type of switch. I do not recommend checking live voltage from the switch yourself. If you carefully checked the wiring of the element and you are certain it is correct, you can try replacing the switch.

If you are still uncertain of the wiring, resubmit your question with additional details referring to specific terminals and wire colors for more help with this repair.

Read More
Lyle W -
Sears Technician
June 09, 2008

Top Parts