Model #9119554590 Kenmore free standing, electric

  • Backguard Section
    3 Results
  • Door Lock Section
    3 Results
  • Main Top Section
    3 Results
  • Body Section
    3 Results
  • Wire Harnesses And Components
    3 Results
  • Oven Door Section
    3 Results

Question and Answers

Q:

Electric freestanding electric range model #9119554590

A:

Thank you for your question and I understand your concern.

It is a very easy procedure to remove and replace the bake or broil elements. The first thing to do is disconnect the power cord from the power source or flip both house circuit breakers off dedicated for the range before removing and replacing the oven element.

Open the oven door and remove the oven racks. To remove the element there are two screws (1/4 inch hex head) to remove securing the element to the rear wall. Once the two screws have been removed slowly pull the heating element towards you until you have access to each one of the wires connected to the element. Pull on the metal spade connector at the end of the wires and not by pulling on the wires to disconnect them from the heating element terminals. Once disconnected be careful with the wires so that they do not recoil back through the openings and out of reach and sight. If this happens then you will have to pull the range out and remove the back panel to access the wires.

Read More
Joey S -
Sears Technician
May 05, 2011
Q:

broiler cuts on automatically

A:

Thank you for your question and I understand your concern.

When baking, the broil element is supposed alternate operation with the bake element. The bake element will stay on for approximately 90 seconds and then the bake element turns off and the broil element will come for approximately 19 seconds and then it turns off and repeats the cycle.

The flashing "Pre-heat" indicator indicates an open or shorted oven temperature sensor. See image below. The oven sensor probe is located inside the oven cavity in the rear upper corner. The sensor can be taken out, disconnected and tested with an Ohm meter for resistance. The sensor should measure approximately 15 Ohms at room temperature according to the data sheet. The oven temperature sensor is part #WB21X158 which can be ordered from Sears PartsDirect . This may be the issue. If not, please reply and I will be glad to assist you further.If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
February 03, 2012