Model #91193814301 Kenmore free standing, electric

  • Control Panel
    3 Results
  • Cooktop
    3 Results
  • Wire Harness & Wiring Components
    3 Results
  • Body Parts
    3 Results
  • Door
    3 Results
  • Door Lock
    3 Results

Question and Answers

Q:

Manual for Kenmore Range Model 911-93814301

A:

Here is a direct link for the manual on that model of Kenmore range: Owner's Manual .

If you need more help, let us know.

Read More
Lyle W -
Sears Technician
August 08, 2011
Q:

I received my bottom element for my Kenmore Oven (911-93814301) and I would like to know if I install it by removing the screws fr inside the unit or behind it?

A:

Thank you for your question and I understand you concern. The bottom oven "BAKE" element can be removed and replaced from inside the oven cavity. First, DISCONNECT THE POWER CORD OR REMOVE THE POWER SUPPLY BY FLIPPING THE TWO HOUSE CIRCUIT BREAKERS OFF DEDICATED FOR THE RANGE.

To remove the "Bake" element, open and remove the door. Removing the door will make it easier. See image below for door removal instructions.

Remove the two (2) screws securing the Bake element to the back panel from inside the oven cavity. Slowly begin to pull the bake element outwards and then disconnect the two wires from the terminals of the bake element. Be careful when you disconnect the wires or they may recoil back through the small openings and then you will have to pull the range out in order to feed the wires back into the oven cavity.

Connect the wires onto the new Bake element, install the two screws, place the door back on and turn the electrical supply back ON and test to see if the bake elements heats.

Read More
Joey S -
Sears Technician
December 17, 2010
Q:

OVEN HEATING ISSUES

A:

Thank you for your question and I understand your concern.

Based on your symptom I would suspect one of two heating elements inside the oven cavity is not working. The bake and broil elements both need to be working in order for the oven to heat properly. Then bake and broil elements cycle during preheat and during the bake cycle. When the oven is cold, start the broiler and check to see if the upper/broil element is getting hot and then place the oven into bake and see if the bake/lower element is heating. You will likely find one of the two heating elements is not working. If one of the elements is not working, it could be caused by a faulty electronic oven control or heating element. The element can be disconnected and tested for continuity with an Ohm meter. NOTE: Disconnect the range from the power supply before removing and testing the element for continuity.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
February 11, 2012

Recommended maintenance parts & accessories

Show 3 more
No more item to show