Model #9113128812 Kenmore wall oven, gas

  • Control Panel
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Upper And Lower Door Lining
    3 Results
  • Upper And Lower Door
    3 Results
  • Wire Harness And Components
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Where can I get a owner manual for kenmore oven 911.3128812?

A:

Thank you for your question.

I have searched for the manual for the oven but did not have any luck. I recommend that you call our Manage My Home Member Services Team at 1-800-803-6775, between 8 a.m. and 8 p.m. Central Time. They will be more than happy to help you track down the manual if it is available.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
November 01, 2011
Q:

My gas wall oven is showing an F3 error?

A:

Thank you for your question and I understand your concern. The "F3" fault code is indication of a temperature sensor probe failure or temperature sensor probe circuit.

The oven temperature sensor can be removed and disconnected from inside the oven cavity. The temperature sensor probe is located in the upper right rear or upper left rear corner. Remove the two screws and pull the sensor out slowly and disconnect the sensor connection. Use an OHM meter to measure the resistance across the wires. The oven temperature sensor should be approximately 1100 ohms at room temperature. If the sensor measures approximately 1100 ohms, check for cut or pinched wires or a loss of contact between the sensor and the control board.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
December 14, 2010