Model #87-1208 MORTEX Air Handler-Blower Kit/Modules (motor,fan,housing)

  • Blower Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

How are the Kenmore upright vacuum 721.33189030 agitator components for 8-1 through 8-7 assembled?

A:

The parts slide over the agitator bar and shaft in the order they are shown in the parts diagram. There are no locking set screws or snap rings holding anything.

When the agitator bar and bearings are assembled, the fixtures slides over them. When the complete assembly is dropped into the base of the vacuum it holds everything in place.

If the agitator bar is damaged or misshaped from the heat of the bearing the agitator bar will have to be replaced.

My information shows your vacuum is pretty new. It might be covered by the warranty if you take it to a Sears Service Center or a Sears Retail Store for repair. The vacuum has a 1 year warranty including parts and labor.

Read More
Jimmy K -
Sears Technician
June 10, 2009
Q:

What is the date of manufacturer of radial arm saw model 113.197750, serial 87 MO345?

A:

The model 113.197750 saw was manufactured in 1977.

Read More
Joey S -
Sears Technician
June 01, 2010
Q:

Kenmore gas dryer, Model 87 880100, glow igniter comes on, burner will not come on

A:

Thank you for your question and I understand your concern.

If you're finding the glow bar igniter glowing red and then fading off without any burner ignition then the most likely problem is weak solenoid coils. The solenoid coils are mounted on top of the gas valve. Replace both solenoid coils at the same time and your gas valve will most likely open and have gas flow to the burner. See image below for instructions.

The solenoid coil kit part # 279834 will include both solenoids. The kit can be ordered from Sears PartsDirect Disconnect the power cord from the power source before removing the access panel.

Read More
Joey S -
Sears Technician
May 27, 2011