Model #848 Wagner airless paint sprayer

  • Final Assy
    3 Results
  • Paint Pump Assy
    3 Results
  • Suction Set Assy
    3 Results
  • G-08 Spray Gun
    3 Results

Question and Answers

Q:

Installation of part # 8546219 on model # 11084832200

A:

Hi Diana,

Thank you for submitting a question to Manage My Life.

The part number you gave me (8546219) is for the central control board or machine control electronics. I am including a set of images below that will demonstrate this procedure. Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts. These images may not look exactly like your dryer but should be similar.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram or to purchase any parts needed; Sears Parts Direct .

I hope this is helpful. If I may be of further assistance please reply to this post.

Landell

Read More
Landell -
Sears Technician
February 09, 2012
Q:

hi, I'm tryn to find a part for my dryer

A:

Thank you for your question.

I am sorry you are having a problem with the dryer. I recommend unplugging the dryer and checking the wiring connection of the thermistor to the electronic control board. The thermistor attaches to the control board on the P2 connector (red/white and black wires on pins 5 and 6). The image below shows the procedure for accessing the control board in this dryer. If the connection is okay, pull the connector off of the control board and check the resistance through the red/white wire and black wire with a volt/ohm meter (with the dryer still unplugged). You should measure about 10K ohms (10,000 ohms) at room temperature. Make sure that your meter is set to the proper range. If you read infinite resistance (open), then you could have a wire harness connection problem between the control board and the thermistor. Check the resistance across the leads of the thermistor (with at least one wire removed from the thermistor). If you measure normal resistance (10K ohms) at the thermistor, then you will need to repair the wiring connection between the control board and the thermistor. If you measure the proper resistance through the thermistor circuit at the connection to the control board (red/white wire to black wire on the P2 connector), then the electronic control board is bad and will need to be replaced.

I hope this is helpful. If you need further assistance, please reply below with more details.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
November 08, 2011