Model #835 WAGNER airless paint sprayer

  • Final Assy
    3 Results
  • Paint Pump Assy
    3 Results
  • Suction Set Assy
    3 Results
  • G-06 Spray Gun
    3 Results

Question and Answers


I have a ProForm 835 QT Treadmill model 831.299481. It was purchased in 2002. The breaker keeps kicking out I'm trying to figure out why.


Be sure the treadmill is getting proper voltage. If you are using an extension cord, try plugging the treadmill directly in a wall outlet.

If you have put oil directly on the walking board and belt, you need to replace the walking belt and clean the walking board. You can only use the lubricant Sears sells to lubricate the belt.

Something is causing the motor to draw excessive amps. This causes the choke to heat up. It sounds like the walking board needs lubricating.

To test the walking belt lubrication, do not turn the treadmill motor on. Set the elevation to the highest level. Stand near the front of the walking belt. Push yourself firmly toward the rear of the treadmill. If the belt is properly lubricated the belt will take you to the rear edge of the treadmill and dump you off on the floor. If you move and stop, the belt needs lubricating.

The part number for the belt lubrication kit is 219168. You can buy it at []. The cost is around $4.00. The application instructions should be in the package, but in case they are not here is how to apply the lubrication.

Turn the walking belt until the belt seam is along the top of the front roller. Raise the belt on one side in the center of the walking board front to back as high as you can. Apply ½ the tube of lubrication to the walking board in a zig zag fashion moving from front to back. Move the belt until the seam comes up on top of the rear roller and lift the belt again and put the rest of the lubrication on the walking board in the same manner. Turn the treadmill on and walk on the belt for 10-20 minutes. Walk all over the belt to distribute the lubrication evenly on the walking belt and board.

Read More
Jimmy K -
Sears Technician
January 15, 2010