Model #830 TROYBILT walk behind lawnmower, gas

  • Transmission Assembly
    3 Results
  • Housing/shift Fork
    3 Results
  • Deck/handle/bag
    3 Results

Question and Answers

Q:

I have a Proform 830 QT treadmill model # 831. 299282 and I would like to calibrate it.

A:

Thank you for your question.  I will be happy to assist you with the calibration mode. I posted an image below that shows how to enter calibration. Click on the image to enlarge it. If you do not see the image, please copy and paste the following link to be taken to the original site to view the image. http://www.managemylife.com/mmh/questions/337606-proform-830-qt-treadmill-model-831-299282-calibrate I hope this is helpful. Please let me know if you need further assistance.  Thank you for using Manage my life. Mark.

Read More
Mark T -
Sears Technician
March 11, 2013
Q:

I have a used treadmill, it is a Proform 830 QT. The choke has something on it and starts to smoke when operating. Is there a way to check the choke to see if it is bad?

A:

You can check the choke with an ohm meter. If you disconnect the choke wires from the terminals they are connected to and test the resistance of the choke, it should read .5 ohms if it is good. It is normal for the choke to get too hot to touch when the motor is running.

You can clean the choke with a mild detergent and warm water. You should remove the choke from the treadmill for cleaning. Water won't damage the choke, but it might damage something else in the treadmill. Let it dry 3-4 hours after cleaning before using it. The coils of wire on the choke are dipped in lacquer so they are waterproof.

Read More
Jimmy K -
Sears Technician
March 18, 2009

Top Parts