Model #80300 TO 80499 (2015 - 2049) Briggs & Stratton engine

  • Replacement Parts
    3 Results
  • Fuel Tank Assembly
    3 Results
  • Rewind Starter Assembly
    3 Results
  • Rewind Starter Assembly
    3 Results

Question and Answers

Q:

The wiring diagram provided by Rachel Morgan on March 09, 2015 was not readeable. 79094192310

A:

I sent you an email with a file attached of the wiring diagram.

Read More
Joey S -
Sears Technician
March 17, 2015
Q:

I have a Janome sewing machine #2049 and it will not stitch. The needle will thread, but then it comes right back out when I try to stitch.

A:

Thank you for your question on the 2049 Janome sewing machine. Please replace with a new needle first.

Please make sure you have threaded the upper thread path correctly.

If you still having the problem then we will need to check the needle to shuttle timing.

Remove the bobbin case from the shuttle and open the bobbin case cover ring but leave the shuttle hook in place.

Next remove the needle plate so you can observe the point of the shuttle for proper timing.

Set the machine to straight stitch setting and O zig zag on the stitch width.

Lean the machine back a little and turn the hand wheel until the needle is at the very bottom of its stroke. Then raise the needle off the bottom only about 3/16 to a 1/4 of an inch off the bottom and observe that the very point of the shuttle hook is at or just above the eye of the needle with the very point of the hook at the center of the needle shaft. If point is before or beyond the needle shaft it will have to be retimed.

If that is the case and the timing is off, you will need to remove the bottom cover on the machine and locate the rock shaft clamp on the right end of the rock shaft and loosen the clamp and then move the shuttle hook point to the proper timing location behind the needle.

If you think that you will not be able to retime the machine properly I would suggest taking it to a Janome service in your area.

Please let me know if this was a successful repair and if you are still having problems please let me know and we can continue to troubleshoot the machine not picking up the bottom thread.

Sam A.

Read More
Sam A -
Sears Technician
March 31, 2012
Q:

Small Spring on lawn mower

A:

Thank you for your question. I am sorry you are having a problem with the mower. I looked at the image you submitted. The spring connects between the throttle shafts on the carburetor to the governor lever. The spring should have a hook on each end. I posted an image below that shows the holes the spring connects too. Click on the image to enlarge it. If you need, I don’t think it will cause any harm if you bent a hook on the end without one now.  I hope this is helpful. Please let me know if you need further assistance.  Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
June 18, 2013